There are a few fundamental measures to take while Venetian Blinds Installation Geelong.
- Make a mark on the wall where you want your brackets to go, making sure they’re level.
- Line up your brackets with the lines on the board.
- Gently screw your brackets into the wall with a drill.
- Secure the blinds using clips.
- Put in a safety device- Once your blind is entirely installed, proceed to the control side and measure at least 1.5m above from the floor. This is where you’ll put your safety device.
We’ll go over all of these fundamental procedures in further depth in this guide to ensure you get the greatest fit for your Venetian blinds. We’ve got all the tips and tricks for getting the ideal fit for these blinds, as well as how to go about doing it.
Before you begin, go over the entire set of instructions to ensure you have all of the necessary tools. (There’s nothing worse than getting started and then having to run to the store.) With our guidance, installing Venetian blinds is simple, especially because they’re custom-made to fit your window. You’ll need a spirit level, a sharp pencil, a tape measure, a masonry drill, drill bits, screws, and wall plug before you begin.
Getting Precise Measurements
Measure the length of the Venetian blinds across the window, then make a pencil mark where your first bracket should go. To ensure that your Venetian blinds fit tightly inside the recess, you may need to subtract about 10mm from your dimensions.
Preliminary Considerations
Before having your blinds built, you’ll have selected where you’ll hang them. They can be attached to the window frame, the wall, or the ceiling, but they are not recommended for use with plastic or aluminum windows since the drill holes cannot be filled. Although the placement of Venetian blinds is sometimes a matter of personal preference, they normally perform better (blocking out light and enhancing insulation) if they are placed within the recess of your window. If there are any impediments, such as window knobs and levers, you may have to compromise and install Venetian blinds on the recess’s outside.
When installing Venetian blinds, keep in mind that the brackets should be placed around 110mm in from the headrail’s ends and can be spread throughout the width as needed.
- Attach your brackets to the underside of the lintel where your Venetian blind will be installed. Be as precise as possible, and use your spirit level to ensure that everything is level.
- Once your brackets are in place, make a note of where both of the screw holes will be.
- Align your marks and the hole on your brackets before placing your screw over the hole and beginning to drill softly.
- Drill the screw into the wood only about two-thirds of the way.
You know how to install Venetian blinds which is fantastic, and they should appear exactly as you anticipated. However, before you consider the job finished, make sure your blinds are safe. The cables, chains, and tapes used to control Venetian blinds can tangle and strangle small children and pets. By simply inserting the cord into a safety device known as a cleat, a calamity can be avoided.
At, City to Surf, for almost 20 years, we’ve been delivering superior installation and repair services in Greater Geelong. Please complete the form to receive a free measurement and quote.